

1-channel KNX RF S-Mode wireless Dimming actuator for DALI Drivers or Ballasts, with LED or Fluorescence lighting.
Allows upgrading the KNX installation without placing KNX bus wires.
Operates in KNX RF+ protocol in System-Mode.
Communication with the KNX Bus must be carried out using a KNX / KNX RF S-Mode
media coupler: “CO K5X 002”.
Power supply: 230VAC 50/60Hz.
Different functions which can be configured with ETS:
· Time of soft on and off.
· Maximum and minimum dimming level.
· Behavior after on telegram.
Staircase time switch and Sequential operation modes.
Auxiliary Pushbutton input with configurable operation.
It incorporates the KNX-RF signal repeater function (optional), which allows extending
the distance between transmitters and receivers.
Adjustable behavior in case of bus voltage failure.
5 pre-configured scenes.
Flush mounted in junction box.
Programming and commissioning by ETS5 via the KNX-RF+ USB stick “CO K5X 001”.
TECHNICAL FEATURES
Reference RE K5X DA1
Power supply 230Vac 50/60Hz
Consumption <3W
Type of Load DALI Drivers or Ballests
Maximum Number of ECGs 64
KNX Medium KNX-RF 1.R
Radio-frecuency 868,3MHz
Transmission Power <10dBm
Range In the free field: 100m // Indoors: 30m
Number of Outputs 1
Application Software ETS5
Commissioning Mode System Mode
Mounting Flush-mounting within universal box
Dimensions 46 x 46 x 30mm
Protection Degree IP20
According to the Standards EN60669-2-1
Compatible with IEC14543-3